Wanted EquipmentSell Your Equipment Financing - Apply now
Equipment Quotes
Balemaster Auto Tie Baler ID: 264432
- Model : BB3230TQ-8
- Serial # B235-01-6001548
- Automatic auto-tie system AT-1-BB4
- 30HP / 600volt
- 8" Cylinder
- 30'' x 32'' feed opening
- Location: Eastern Canada
View more Recycling Equipment
Schoma 40 Ton Tunnel Locomotive ID: 177408
- Year: 2005.
- Drive system: Diesel-hydrostatic.
- Usage: tunnel & underground.
- Track gauge: 1000 mm (can be changed to 900 mm).
- Deutz 250 HP diesel engines.
- Max. speed: 32 km/h.
- Min. curve radius: 40 m.
- Min. track clearance: 15 mm.
- Structure:
- Continuous main frame in box design.
- Engine compartment with access flaps for maintenance purposes.
- Fuel tank mounted on main frame and protected against collisions.
- Rail guards adjustable in height.
- Electric components inside enclosed cubicle in the drivers cabin.
- Locomotive main frame:
- Main frame in box design with high torsion resistance.
- MAG welded.
- Side plates with cut-outs for inspection of axle gears, brake gears, etc.
- 2 lifting points at both sides.
- Operators cabin:
- 2 door cabin.
- One operators desk with ergonomic arrangement of controls and levers.
- Front window equipped with wipers.
- Fuel system:
- Filler caps at both sids of the locomotive.
- Fuel gauge on operators panel.
- Fuel tank capacity: 600 L approx.
- Quantity: 1.
View more Diesel Operated Locomotives
TIME Advanced Stoper Longhole Drill ID: 1398203
TIME Advanced Stoper Longhole Drill
- Make: TIME
- Model: Advanced Stoper
- Year: 2023
- Type: Longhole Drill
- Condition: New, No Hours
- Drill: S36 IR Drifter Drill
- Aluminum Feed
- Heavy-Duty Centralizer (Used)
- Nominal Diameter: 35 - 89 mm (1.38in-3.5in)
- Nominal Length: Up To 46m (Up To 150ft)
- Reamed Diameter: Up To 127mm (Up To 5in)
- Blows/Minute: 1630 @ 500 kPa (1630 @ 72.52 PSI)
- Air Consumption: 14m³/min @ 500 kPa (494.41 CFM @ 72.52 PSI)
- Traverse: 5ft Traverse
- Side to Side Hole Positioning of 66in (168cm)
- (3) Helac Actuators for Increased Stability and Less Wear Parts
- 135° Dump, 360° Radial and an Optional 180° Pivot Positioning
- 135° Dump, 360° Radial and an Optional 180° Pivot Positioning
- Carrier:
- 30HP Radial Piston Air Motor (@1200 RPM)
- 116 PSI & 890 CFM Air Delivery
- Tandem Gear Hydraulic Pump
- 1.91in³ Per Rev. @3000 PSI
- High Quality Proportional Directional Control Valves
- High Quality Motion Control and Cross-Port Check Valves
- Two Lever Pilot (Low) Pressure Tethered Remote Tramming Valve
- Skid Steering with Independent Port and Starboard Wheel Drives
- Planetary 4-Wheel Hydraulic Drive with Fail-Safe Brakes
- 4 Independent Heavy-Duty Jacks with Load Lock (Cross Port Check) Valves for Leveling
- Tow-Bar and Dis-Engaging Wheel Drives for Towing
- Rotation Barrier – Double Hinged (Opens from the Left or Right Side)
- 30HP Radial Piston Air Motor (@1200 RPM)
- Location: Eastern Canada
View More Jumbo Drills
CAT 1500 kW Generator ID: 218351
- Year: 1987.
- 150 kW
- Dulce valve and Huron actuator.
- CAT 3516 engine.
- 2168 HP.
- 1800 RPM.
- 277/480 volt.
- 3 phase.
- Generator Model: SR-4
- EMCP digital control panel.
- 2000 amp main-line circuit breaker.
- Weather enclosure.
- 200 gallon (approx.) sub-base day tank.
- 284 in. long x 106 in. wide x 123 in. high.
- Weight: 40,000 lbs.
- Location: Europe.
View more Diesel Generators
Manufacturer: | CAT |
Atlas 3 ½ in. x 5 ½ in. Laboratory Jaw Crusher ID: 665465
- Jaw Opening: 3 ½ in. x 5 ½ in
- Mounted on 2 ft. x 3 ft. Common Base
- 2 HP Motor & Drive
- Flywheel Guard
- Drive Guard
- Feed Hopper and Ore Pan
- Location: British Columbia, Canada
View more Lab Jaw Crushers
General Electric Stop/Start ID: 1388746
General Electric Stop/Start
MAX V: 600V
CR2943NAI02CA
- Location: Savona, British Columbia, Canada
Baldor 7.5 HP Motor ID: 191305
- ID No.: F-6670-01-629.
- Volts: 230/460V.
- RPM: 3490.
- Frame: 213T.
- Phase: 3.
- Shaft Length: 3 3/4 In.
- Shaft Diameter: 1 1/4 In.
View more 7.5 HP Motors
Siemens 200 Amp Disconnect ID: 157604
- 240V.
- 2 wire.
- Single phase.
- Suitable for service entrance.
Please contact us for more information.
View more 200 Amp Disconnects
Manufacturer: | SIEMENS |
Allen-Bradley Power Switch ID: 1396344
Allen-Bradley Power Switch
2 Pole Only
3/4HP
115-230V DC MAX
1 or 2 Pole
1HP
120-240V AC MAX
- Location: Savona, British Columbia, Canada
2000 Amp 3 Pole Breaker ID: 516613
2000 Amp
3 Pole
Stainless Steel 10 cu. ft. Conical Hopper ID: 193293
- 40 In. Diameter x 45 In. Overall Height.
- Top has a 24 In. Square Flanged Inlet.
- Three level probes.
- 4 In. Inlet Pneumatic Vent Line.
- Outlet of Hopper is a round 12 In. Diameter Flanged Outlet.
View more Hoppers
Red White 4 in. Gate Valve ID: 730122
- Size: 4 in.
- Class: 125
- Body: C.I
- Body Seat: Bronze
- 8 Bolt Flanged Ends
- Location: British Columbia, Canada
View more Gate Valves
Baldor 5 HP VFD ID: 187829
- Input
- 460 VAC
- 50/60 Hz
- Output
- 460 VAC
- 0 - 400 Hz
- Cat #: ID15405-E
- Quantity 1
View More 5 HP VFDs
Manufacturer: | BALDOR |
Edem 18 in. x 30 ft. Vibrating Conveyor ID: 76388
- 18 in. wide x 30 ft. long.
- 11 in. high sides.
- Mounted on steel beam frame.
- 7.5 hp electric motor.
- 575 volt, 1740 rpm.
- Fibreglass section for metal detector.
- With Rens A10-36 Metal detector.
View more Vibrating Conveyors
Fuse Holder ID: 1256787
Sylvania 1 Pole 15 Amp Breaker ID: 335669
- 1 Pole
- Amp: 15
- Volt: 120/240
- Style: Bolt In
- Type: QB
- Single Phase
- Location: British Columbia, Canada
View more Breakers
Siemens 125 HP Motor ID: 160361
- 460V.
- 3575 rpm.
- 3 phase.
- 60 Hz.
- Frame: 444TS.
- 138 Amps.
Please contact us for more information.
View more 125 Horsepower Motors
Manufacturer: | SIEMENS |