Wanted EquipmentFinancing - Apply now

Equipment Quotes

Balemaster Auto Tie Baler ID: 264432


  • Model : BB3230TQ-8
  • Serial # B235-01-6001548
  • Automatic auto-tie system AT-1-BB4
  • 30HP / 600volt
  • 8" Cylinder
  • 30'' x 32'' feed opening
  • Location: Eastern Canada

View more Recycling Equipment

Schoma 40 Ton Tunnel Locomotive ID: 177408


  • Year: 2005.
  • Drive system: Diesel-hydrostatic.
  • Usage: tunnel & underground.
  • Track gauge: 1000 mm (can be changed to 900 mm).
  • Deutz 250 HP diesel engines.
  • Max. speed: 32 km/h.
  • Min. curve radius: 40 m.
  • Min. track clearance: 15 mm.
  • Structure:
    • Continuous main frame in box design.
    • Engine compartment with access flaps for maintenance purposes.
    • Fuel tank mounted on main frame and protected against collisions.
    • Rail guards adjustable in height.
    • Electric components inside enclosed cubicle in the drivers cabin.
  • Locomotive main frame:
    • Main frame in box design with high torsion resistance.
    • MAG welded.
    • Side plates with cut-outs for inspection of axle gears, brake gears, etc.
    • 2 lifting points at both sides.
  • Operators cabin:
    • 2 door cabin.
    • One operators desk with ergonomic arrangement of controls and levers.
    • Front window equipped with wipers.
  • Fuel system:
    • Filler caps at both sids of the locomotive.
    • Fuel gauge on operators panel.
    • Fuel tank capacity: 600 L approx.
  • Quantity: 1.

 

View more Diesel Operated Locomotives

TIME Advanced Stoper Longhole Drill ID: 1398203


TIME Advanced Stoper Longhole Drill

  • Make: TIME
  • Model: Advanced Stoper
  • Year: 2023
  • Type: Longhole Drill
  • Condition: New, No Hours
  • Drill: S36 IR Drifter Drill
    • Aluminum Feed
    • Heavy-Duty Centralizer (Used)
    • Nominal Diameter: 35 - 89 mm (1.38in-3.5in)
    • Nominal Length: Up To 46m (Up To 150ft)
    • Reamed Diameter: Up To 127mm (Up To 5in)
    • Blows/Minute: 1630 @ 500 kPa (1630 @ 72.52 PSI)
    • Air Consumption: 14m³/min @ 500 kPa (494.41 CFM @ 72.52 PSI)
  • Traverse: 5ft Traverse
    • Side to Side Hole Positioning of 66in (168cm)
  • (3) Helac Actuators for Increased Stability and Less Wear Parts
    • 135° Dump, 360° Radial and an Optional 180° Pivot Positioning

  • Carrier: 
    • 30HP Radial Piston Air Motor (@1200 RPM)
      • 116 PSI & 890 CFM Air Delivery
    • Tandem Gear Hydraulic Pump
      • 1.91in³ Per Rev. @3000 PSI
    • High Quality Proportional Directional Control Valves
    • High Quality Motion Control and Cross-Port Check Valves 
    • Two Lever Pilot (Low) Pressure Tethered Remote Tramming Valve 
    • Skid Steering with Independent Port and Starboard Wheel Drives 
    • Planetary 4-Wheel Hydraulic Drive with Fail-Safe Brakes 
    • 4 Independent Heavy-Duty Jacks with Load Lock (Cross Port Check) Valves for Leveling 
    • Tow-Bar and Dis-Engaging Wheel Drives for Towing 
    • Rotation Barrier – Double Hinged (Opens from the Left or Right Side)

  • Location: Eastern Canada

View More Jumbo Drills

CAT 1500 kW Generator ID: 218351


  • Year: 1987.
  • 150 kW
  • Dulce valve and Huron actuator.
  • CAT 3516 engine.
    • 2168 HP.
    • 1800 RPM.
    • 277/480 volt.
    • 3 phase.
  • Generator Model: SR-4
  • EMCP digital control panel.
  • 2000 amp main-line circuit breaker.
  • Weather enclosure.
  • 200 gallon (approx.) sub-base day tank.
  • 284 in. long x 106 in. wide x 123 in. high.
  • Weight: 40,000 lbs.
  • Location: Europe.

 View more Diesel Generators

Manufacturer:CAT

Atlas 3 ½ in. x 5 ½ in. Laboratory Jaw Crusher ID: 665465


  • Jaw Opening: 3 ½ in. x 5 ½ in
  • Mounted on 2 ft. x 3 ft. Common Base 
  • 2 HP Motor & Drive
  • Flywheel Guard 
  • Drive Guard 
  • Feed Hopper and Ore Pan
  • Location: British Columbia, Canada

View more Lab Jaw Crushers

General Electric Stop/Start ID: 1388746


General Electric Stop/Start

MAX V: 600V

CR2943NAI02CA

  • Location: Savona, British Columbia, Canada

Baldor 7.5 HP Motor ID: 191305


  • ID No.: F-6670-01-629.
  • Volts: 230/460V.
  • RPM: 3490.
  • Frame: 213T.
  • Phase: 3.
  • Shaft Length: 3 3/4 In.
  • Shaft Diameter: 1 1/4 In. 

View more 7.5 HP Motors 

Siemens 200 Amp Disconnect ID: 157604


  • 240V.
  • 2 wire.
  • Single phase.
  • Suitable for service entrance.

 

Please contact us for more information.

View more 200 Amp Disconnects

Manufacturer:SIEMENS

Allen-Bradley Power Switch ID: 1396344


Allen-Bradley Power Switch

2 Pole Only

3/4HP

115-230V DC MAX

 

1 or 2 Pole

1HP

120-240V AC MAX

  • Location: Savona, British Columbia, Canada

 

2000 Amp 3 Pole Breaker ID: 516613


2000 Amp

3 Pole

Stainless Steel 10 cu. ft. Conical Hopper ID: 193293


  • 40 In. Diameter x 45 In. Overall Height.
  • Top has a 24 In. Square Flanged Inlet.
  • Three level probes.
  • 4 In. Inlet Pneumatic Vent Line.
  • Outlet of Hopper is a round 12 In. Diameter Flanged Outlet. 

View more Hoppers

 

Red White 4 in. Gate Valve ID: 730122


  • Size: 4 in.
  • Class: 125
  • Body: C.I
  • Body Seat: Bronze
  • 8 Bolt Flanged Ends
  • Location: British Columbia, Canada

View more Gate Valves

Baldor 5 HP VFD ID: 187829


  • Input
    • 460 VAC
    • 50/60 Hz
  • Output
    • 460 VAC
    • 0 - 400 Hz
  • Cat #: ID15405-E
  • Quantity 1

View More 5 HP VFDs

Manufacturer:BALDOR

Edem 18 in. x 30 ft. Vibrating Conveyor ID: 76388


  • 18 in. wide x 30 ft. long.
  • 11 in. high sides.
  • Mounted on steel beam frame.
  • 7.5 hp electric motor.
    • 575 volt, 1740 rpm.
  • Fibreglass section for metal detector.
    • With Rens A10-36 Metal detector.

View more Vibrating Conveyors 

 

Browse Equipment Remove AllSubmit Quote
First Name
Last Name
Email Address
Phone
Questions, Information and Comments
Project Location

Additional Information

Additional information is helpful to make sure we provide you with the best service possible. However it is not required

Company
Address
City
Country
State / Province
ZIP Code
Website
Ore / Material
Tons Per Hour