Equipment Quotes
2 AWG 3C MV105 15kV EPR/PVC Power Cable ID: 1396801
2 AWG 3C MV105 15kV EPR/PVC Power Cable
Qty: 3,000 Feet
- Size: 2 AWG
- Conductor: 3-Conductor
- Voltage: Up to 15,000 Volts
- Voltage Rating: Medium Voltage
- Max Temp: 105°C (140°C for Emergency Overload Conditions, and 250°C for Short Circuit Conditions)
- Insulation: Ethylene-Propylene Rubber
- Jacket: Sunlight Resistant PVC
- 4 Connector/Plugs - Patton & Cooke Co. CT150F2001 (500A Rated)
- Location: Western USA
View More Cabtire Cable
1120kW Mitsubishi Diesel Generator ID: 1155199
1120kW Mitsubishi Diesel Generator
- Make: Mitsubishi
- Model: S16N-PTA
- Year: 1988
- Portable/Stationary: Stationary
- Engine: Mitsubishi 16-Cyl Turbo Diesel (1420HP)
- Hours: 685
- Oil: Capacity - 230 Liters (60.8 US Gal)
- Radiator: Capacity - 350 Liters (92.5 US Gal)
- Generator: Stamford
- kVA/kW: 1120kW (1400kVA)
- RPM: 1500 RPM
- Voltage: 415/240V (or Any Volt Between 380V–440V)
- Amperage: 1950A
- Frequency: 50Hz
- Phase: 3-Phase
- Output Panel: Voltmeter, Ammeter, Control Center
- Additional Information:
- Skid-Mounted
- Radiator Cooled
- Mounted Control Panel
- Fitted In A Sound-Attenuated 30ft Container
- The Set Has Been Deployed As A Standby Power Unit In A Top UK Company, Has Been Professionally Maintained And Fully Load Tested Annually
- Overall Dimensions: 30ft Sea Can
- Length: 30ft
- Width: 8ft
- Height: 8.5ft.
- Weight: 22,600 Kgs Approx.
- Location: Europe
View More 1001-1500kW Diesel Generators
2500 kVA Transformer ID: 205730
- 11 kV - 433V.
- Phase: 3.
- Hz: 60.
- NLTC on HV.
- Vector Group Dyn11.
- IZ = 7.34% @ 2500 kVA.
- IEC Standard.
View more Liquid Filled Transformers
Holland 10in x 10in Self Priming Portable Pump ID: 1405084
Holland 10in x 10in Self Priming Portable Pump
- Make: Holland
- Type: 10in Suction Lift Pump
- Condition: Used, Reported in Good Condition
- Flow Rate: 4,400 GPM (Approx.)
- Suction: 10in
- Discharge: 10in
- Air Prime Assist
- Murphy Control Switch
- Drive: Deutz Air Cooled Diesel Engine
- Model: F6L-912
- On Single-Point-Lift Operating Frame
- With Built-In Fuel Tank
- Location: Northwest USA
View More Portable Pumps
Joslyn Clark Vacuum Contactors ID: 313033
- Control Voltage:
- 110-120 Volt
- 220-240 Volt
- 50/400 Hz
- Boot Covering Included
- 6 Units Available
- Location: Western Canada
View more Vacuum Contractors
Opperman/Power Flow Right Angle Reducer ID: 252153
- Type: PF6H
- Ratio: 30:1
- Location: Western Canada
View more Right Angle Reducers
90 AMP GOULD ONE TIME NRS 90 ID: 357618
90 AMPS
VAC= 600V A.C. or less
CLASS: N
TYPE: NRS
LENGTH: 8"
Ford V10 450 Service Truck ID: 479982
- Comes with
- Welder
- Air Compressor
- Location: Western Canada
View more Service Trucks
Novatec POD-250 Silo Dehumidifiers ID: 220677
- POD series silo dryer maintains a slight positive pressure inside the silo, expelling moisture and preventing the introduction of humid air.
- Unit mounts inside silo skirt.
- Model: POD-250
- Air flow:
- CFM: 250.
- M3/hr: 425
- Dimensions: 53 in. wide, 58 in. long, 36 in. deep.
- Location: Eastern Canada
- Contact for more information.
View more Silos
Manufacturer: | NOVATEC |
Saftronics 20 HP VFD ID: 169390
- Input
- 3 Phase
- 200-230 VAC
- 50/60 Hz
- 65 Amps
- Output
- 3 Phase
- 0-230 VAC
- 0-400 Hz
- 54 Amps
- Model #: CIMR-P5U2011
- No Controller
- Quantity 1
View More 20 HP VFDs
Manufacturer: | SAFTRONICS |
Crompton 0-500 kW Analog Wattmeter ID: 179910
- 3 Phase
- 5 Amp 100:1 CT Requirements
- 120 VAC 5:1 PT Requirements
- Quantity 1
View More Wattmeters
Manufacturer: | CROMPTON |
Eriez 62U Industrial Vibrator ID: 88017
- 115 volt.
- Style: 07.
- Model: 62U
- Electro magnetic type vibrator.
- 2 bolt mounting.
Lowe 750 Hydraulic Auger ID: 1405369
Lowe 750 Hydraulic Auger
- Make: Lowe
- Model: 750
- Condition: Unused
- Hydraulic Flow Rating: 8-20gpm (30.3-75.7Lpm)
- Max Rotation Speed: 161RPM
- Max Pressure: 3,300psi
- Torque at 3,000psi: 1,006lbs/ft
- 3 Auger Sizes
- Universal Skid Steer Mounting System
- Location: Western Canada
View More Skid Steer Attachments
Westinghouse Nova Line 200 Amp Disconnect ID: 157595
- 240V.
- HP: 25-20.
- 4 wire.
- 3 phase.
- Suitable for service entrance.
Please contact us for more information.
View more 200 Amp Disconnects
BQ Drill Rod ID: 43042
- BQ Drill Rod
- 2000 feet
- Comes in 10 foot lengths
Schutte Buffalo WA25H Hammermill ID: 1392585
Schutte Buffalo WA25H Hammermill
- Make: Schutte Buffalo
- Model: WA 25 H
- Series: WA Series
- Type: Hammermill
- Condition: Used, Reported in Good Condition
- RPM: 1800
- Hammer: 6698A
- DWG: 9098B
- Feed Opening: 12in x 25.5in
- Housing: 5/8in (15mm)
- Shaft Diameter: 3.375 (85mm)
- Rotor Diameter: 24in (610mm)
- Bearings: 2.75in (60mm)
- Wear Plate Thickness: 0.675in (15mm)
- With Electrical Motor
- Power Output: 40HP
- Voltage: 230/460 Volt
- Mounted on Stand
- Dimensions:
- Length: 9ft
- Width: 6ft
- Height: 8ft
- Weight: 7,500 Lbs. Approx.
- Location: Western Canada
View More Hammermills
225 Amp Westinghouse KA Frame ID: 45976
- 225 amp Westinghouse KA frame.
- Adjustable trip.
Manufacturer: | WESTINGHOUSE |
Demag AC 500/2 SSL Mobile Crane ID: 345843
- Capacity: 50 ton
- Year: 2008
- Boom: 56m
- Luffing Jib: 90m
- Fixed Jib: 62m
- Superlift Sideways: SSL
- Counterweight: 180 ton
- 22,900 km
- Hours: 5,800
- Location: Europe
View more Mobile Cranes
General Electric 40 HP Motor ID: 155374
- 460V.
- 3,565 rpm.
- 3 phase.
- Frame: 324TS.
Please contact us for more information.
View more 40 HP Motors
50 KVA 480 - 120/240 Single Phase Indoor Dry Acme Transformer ID: 46093
50 KVA 480 - 120/240 Single Phase Indoor Dry Acme Transformer
1000kW Cummins Diesel Generator ID: 1394614
1000kW Cummins Diesel Generator
- Make: Cummins
- Model: DQFAD-1992041
- Year: 2019
- Duty: Standby
- Condition: Used, Reported in Excellent Condition
- Fuel Tank: 2,000 Gallon Diesel Base Tank
- Stationary/Portable: Stationary
- Engine: QST30-G5 NR2
- Hours: 56.3
- Oil: Capacity - 154 Liters (162.8 Quarts)
- Radiator: 50°C Ambient, Coolant Capacity (with Radiator) - 201 Liters (53.2 Gallons)
- Generator: Cummins
- kVA/kW: 1000kW (1250kVA)
- Speed: 1800 RPM
- Voltage: 347/600 Volts
- Current: 1202.8 Amps
- Frequency: 60Hz
- Phase: 3-Phase
- Location: Western Canada
View More 501-1000kW Diesel Generators
DeVilbiss-Hankison Compressed Air Dryer ID: 43090
- Model 8010
- Rated Capacity 10 SCFM
- Max. Working pressure 150 PSI
- 115 Volt
- 1 Phase
- 60 HZ
- Refrigerant R12
- Location: Savona BC.
Shred-Tech ST-15 Shredder ID: 1417509
Shred-Tech ST-15 Shredder
- Make: Shred-Tech
- Model: ST-15
- Year 2018
- Condition: Used Condition
- Throughput: Up To 1 TPH
- Duty: Light Duty Applications
- Horsepower: 30HP
- Voltage: 575 Volt
- Frequency: 60Hz
- Rotating Speed: 1775 RPM
- Knife Diameter: 6.75in
- Hex Size: 2.6875in
- Distance Between Shafts: 5.875in
- Cutting Chamber: 13in x 21in
- Hopper Height: 38in Overall
- Location: Eastern Canada
View More Industrial Shredders
Make: | Shred-Tech |
Model: | ST-15 |
Year: | 2018 |
Radicon 70:1 Gear Reducer ID: 292167
- Model: AU-12
- Order: SP840240B
- Rated for 47 HP
- 70:1 Ratio
- Input Shaft Size: 2.5in.
- Output Shaft Size: 3.7in.
- Location: Western Canada
View more Right Angle Reducers
Endress Hauser Flowmeter ID: 1387502
Endress Hauser Flowmeter
Ser-No. CFQ0162
Pmax. 64000 in H20
4...20mA HART
MAT. CRNI-Steel Viton C22.8
- Location: Savona, British Columbia, Canada
Trans-Coil 10 HP Line Reactor ID: 172702
- 600 VAC
- 3 Phase
- 60 Hz
- Cat #: KLR16ATB
- KLR Series
- Quantity 3
View More 10 HP Line Reactors
Manufacturer: | TRANS-COIL |
7 ft. Dia. x 4 ft. Hardinge Conical Mill. Complete with Air Sweep System. ID: 43977
7 ft. Dia. x 4 ft. Hardinge Conical Mill. Complete with Air Sweep System.
Marathon Electric 200 HP Motor ID: 193326
- Model: XX445TTDS4036ANW.
- Volts: 460V.
- RPM: 1780.
- Phase: 3.
- Frame: 449TS.
View more 200 HP Motors
(2) Atlas Copco Boltec MC ID: 1272109
Atlas Copco Boltec MC
Quantity: 2 Units
- Make: Atlas Copco
- Model: Boltec MC
- Year: 2013 and 2016
- Condition: Used, Reported in Good Condition
- Hours:
- 001: 2397.6 Hours
- 002: 1116.1 Hours
- ROPS/FOPS Approved
View Spec Sheet Below - General Model Specifications: See Attached Spec Sheets for More Technical Information
- Drifter: COP 1132
- 11kW Impact Power
- Hole range: 31 mm to 51 mm
- Bolt Lengths: 1.5-3.5m
- Effective in Roof Heights up to 9.5m
- Shank: R25 - R28 - R32
- Diesel Motor: 120kW
- Electric Motor: 63kW
- Compressor: GAR 5
- Machine Weight: 21.600kgs
- Rig Control System (RCS)
- Magazine for 10 Bolts
- Overall Dimensions:
- Length: 13,405mm (528in)
- Width: 2,245mm (88in) - Without Bolt Rack
- Height: 3,021mm (119in)
- Weight: 21,600Kgs
- Location: Western Canada
View More Jumbo Drills